Test set-up model WISE-8

Test set-up model WISE-8

Test set-up for Wise in the Towing Tank models can be seen in Figure 1.

         

             


  

 Figure 1. Model Test Set-Up.

Figure 2. Position gauge pressure transducers on the model WISE
 
Before the implementation of the model testing, performed heavy arrangements and emphasis WISE prototype model of the size-8 with reference to the equation 'Froude Law'. Frame hook is used to adjust the height and angle of landing model, in which the frame is mounted and attached to the trains pull (towing carriage). Pressure transducer measuring instruments (Ø = 1.3 cm diameter) installed at some point (area) below the surface of the model have been determined.
Configuration pressure transducer mounted below the surface of the model can be seen in Figure 3, the pressure transducer position in the model is denoted as follows:
- F1: in front midship area
- F4: the midship area
- F6: on rear midship area
- F7: the pontoon section Starboard
- F8.: The portside pontoon section.